CR-GC00-H640x汽車(chē)總裝

         Standard Conbbbbity The cameras have been tested in the following conditions:

        ? Shielded power supply cable

        ? Camera bbbb® data transfer cable ref. 14B26-SZLB-500-OLC (3M ? Linear AC-DC power supply 

        ? e2v recommends using the same configuration to ensure the compliance with the following standards 6.1 CE Conbbbbity AViiVA Cameras comply with the requirements of the EMC (European) directive 89/336/CEE (EN 50081-2, EN 61000-6-2).

        FCC Conbbbbity AViiVA Cameras comply with Part 15 of FCC rules. Operation is subject to the following two conditions: 

        ? This device may not cause harmful interference, and 

        ? This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

        Setting Command bbbbbeter Debbbbbbion Configuration record(1) E= 0 1 The camera configuration is recorded on each change The camera configuration is recorded only on request Gain(2) G= 0 to 851 Gain setting from 0 to 40 dB (~0.047dB steps) Even Gain(2) A= 0 to 20 Even pixels gain adjustment (odd – even mismatch adjustment) Odd Gain(2) B= 0 to 20 Odd pixels gain adjustment (odd – even mismatch adjustment) Data transfer(3) H= 0 1 3 5 6 7 8 9 10 Two outputs on external clock One output (multiplexed) on external clock One output (multiplexed) at 20 MHz data rate One output (multiplexed) at 30 MHz data rate Two outputs at 20 MHz data rate One output (multiplexed) at 40 MHz data rate Two outputs at 30 MHz data rate One output (multiplexed) at 60 MHz data rate One output (multiplexed) on external clock (data frequency / 2)(7) Output bbbbat(4) S= 0 1 2 12-bit Output data 10-bit Output data 8-bit Output data